I have followed instructions on trying to pull codes from my ECM via the green and red led's. My computer doesn't have any lights or a place to rotate a slotted screw driver clockwise.

I do have a data link connector below my interior fuse box. However, my OBDI scanner does not have a Nissan connector.

Is there another way to manually retrieve my engine codes?

Thanks for any expertise or experience you might have.

I only find ways in Jeep Cherokee... not sure if that applies to your ECM.

Now that's funny, but you are right, it doesn't help me in the least.:(

sorry to hear that buddy :(

In case anyone else runs across this problem, I found the answer in the factory service manual here http://www.nicoclub.com/FSM/quest/1994-1995_Quest/ec.pdf

I also found a you tube video here http://www.youtube.com/watch?v=sS1SHA2M6Ok

Happy repairing!

nice!that's very useful, I've bookmark it thanks for sharing!

that's an nice stuff it would help me a lot thanks for the post and good job guys.