Cannot Remoe Rotor
#1
02-07-2009 | 08:47 PM
Thread Starter
Joined: Mar 2008
Posts: 2
Cannot Remoe Rotor
2005 Sentra.
1.8L engine.
Front disc brakes ...
Caliper is removed.
Removed the hair pin through the center axle (is that the name?) protecting the 30mm nut.
Removed the 30mm nut holding the rotor to the center axle.
I see that the rotor is pressed in onto the spline center axle.
Rubber mallet the rotor ...
It is not loosening.
Are there screws holding it?
Do I need a puller?
HELP !!!
- billincentraljersey
1.8L engine.
Front disc brakes ...
Caliper is removed.
Removed the hair pin through the center axle (is that the name?) protecting the 30mm nut.
Removed the 30mm nut holding the rotor to the center axle.
I see that the rotor is pressed in onto the spline center axle.
Rubber mallet the rotor ...
It is not loosening.
Are there screws holding it?
Do I need a puller?
HELP !!!
- billincentraljersey
#2
02-25-2009 | 02:26 AM
Junior Member
Joined: Feb 2009
Posts: 2
From: Winston Salem, NC
hope this helps
I have an SE-R so the front rotors are not the same. Make sure you take the caliper mount off that holds the brake pads and if there are screws they will be on the face of the rotor were the studs go through the rotor. If you have done all of this then the only thing holding it on should be rust. If this dosen't help you could send some photos. Hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post